INSTALLATION INSTRUCTIONS
Before Using Your Beverage cooler
-
Remove the exterio r and interior pack aging.
-
Check to be sure you have all of the f ollowing parts:
o
3 Shelves
o
2 Keys
o
Stainless Steel Handle
o
Instruction Manual
o
2 Extra Screws for Installing Handle
-
IMPORTANT: Before connecting this Beverage cooler to a power source , let it stand upright
for approximately 24 hours. This will reduce the possibility of a malfunction in the cooling
system from handling during transportat ion.
-
Clean the interior surface with lukewarm water using a soft cloth.
-
Install the handle on the left side of the door.
To Install Stainless Steel Handle
1) Pull away the door gasket in the area where the handle is to be installed, as Illustration #1.
The gasket i s easily removed by hand, no tool s are necessary.
2) Align the handle with the preinstalled screws on the door frame. Tighten the screws with a
screwdriver until the handles sec ure tightly against the door frame, as Illustration #2. (Do NOT
over tighten as this will c
ause damage to the handle assembly).
3) Repl ace the door gasket to its original position.
Note: This Beverage cooler includes stainless steel handles that are not required to operate this
Beverage cooler. If you choose not to use the handle suppl ied, simply follow step 1 to access the
pre-installed screws and remove them and then place 2 decorative plugs (NOT included ) into the
two holes separately. Continue on to step 3 to replace the door gaske t to its original position.
To Next Page
Loading...
General