Illustration #1 Illustration #2
To Install Your Beverage cooler
-
This Beverage cooler is des igned f or free stand ing or built- i n (fully recesse d) installation.
-
Place your Beverage cooler on a solid and leve l floor that is strong enough to support it when
it is fully loaded. This will ensure a vibration-f ree and noise-free operation. Adjust the leveling
legs in and out to stabilize the cooler horizo ntally. If the legs are not properly adjusted, the
cooler may be unstable and result in excess noise or vibration.
-
Locate the Be verage coole r away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources m ay increase
electrical consumption. Extremely cold ambie nt temperatures may also cause the cooler not
to perform properly.
-
It is not advisable to install this cooler in moist areas or directly adjacent to a kitchen sink, as
moisture could cause premature corrosion to the com ponents of your new cooler.
-
It is recommended you install the Beverage cooler in a place with temperatures above 60°F
(15°C) and below 90°F (32°C), and humidity is unde r 60%. If the ambie nt temperature is
above or below recommend e d temperatures, the performance of the cooler may be affected.
Placing your cooler in extremely cold or hot conditions may cause interior temperature s to
1 Gasket
2 Screw
3 Screw Driver
4 Handle
To Next Page
Loading...
General