WARNING
1. Ensure batteries are inserted with the positive (+) end pointing towards the head. The MT10C will not be
operational with incorrectly inserted battery.
2. The included battery magazine securely holds the (R)CR123 battery in place, thus stopping battery movement
in the compartment.
3. Please stop using and remove a depleted IMR18350 battery to avoid potential battery damage.
Momentary Illumination
Momentary illumination can be achieved by switching the flashlight off and holding the tail switch halfway down.
Releasing switch turns the light off.
On / Off Operation
To switch ON: Press the button on the tail cap all the way down until a click is heard.
To switch OFF: Press the button on the tail cap all the way down once again until a click is heard.
Standby Mode: When power is off, press both side switches and the button on the tail cap simultaneously to
activate the red power indicator to flash and indicate battery voltage. Three seconds after electrical voltage is
reported, the MT10C enters standby mode where the indicator flashes once every three seconds. In standby mode,
the MT10C will operate for approximately six months with the indicator on.
Brightness Levels
When the MT10C is switched on. press the step-up switch repeatedly to switch from the following brightness
levels: red beacon-red light-ultralow-low-rnedium-high-turbo. The MT10C has memory effect. When it is switched on,
the MT10C will enter the brightness level last used.
When the MT10C is switched on. press the step-down switch repeatedly to lower its brightness until red beacon
To Next Page
Loading...
Need help?
General
