mode. after which there is no cycling back to other brightness levels.
Direct Access to Red Light Mode:
When the MT10C is switched on, press and hold the step- down switch for over one second to access the red
light mode: OR:
When the MT10C is switched off, press and hold the step-down switch and press the button on the tailcap to
access the red light
Direct Access to Turbo:
When the MT10C is switched on. press and hold the step -up switch for over one second to access turbo output
(920 lumens): OR:
When the MT10C is switched off, press and hold the step-up switch on the tailcap to access turbo output (920
lumens).
Note: After three minutes’ using of turbo mode, the flashlight will lower its output automatically to prevent
overheating. and efficiently ensure the battery runtime.
Special modes (Strobe/Location/SOS)
With the light switched on. press both side switches to enter strobe mode. When in strobe mode. press both
side switches again to cycle through Location Beacon, SOS, and Strobe modes. To exit and resume t e
.rightness level last used, simply press the step-up or step-down switch. The MT10C has memory effect in
strobe mode. If it is turned off in strobe mode, it will enter strobe mode immediately when switched on again.
Power Tips
With the light switched off, press both side switches and the button on the tailcap to activate the red power
indicator to blink and indicate battery voltage (accurate to 0.1V). For example, when battery voltage is at 4.2V. the
red power indicator will blink 4 times, followed by a one second pause and another 2 blinks. Different voltages
represent the corresponding remaining battery power levels.
IMR18350
CR123
Changing / Charging Battery
Battery should be replaced or recharged when output appears to be dim or the flashlight becomes unresponsive.
Maintenance
Every 6 months, threads should be wiped with a clean cloth followed by a thin coating of silicon-based lubricant.
Warranty Service
All NITECORE® products are warranted for quality. Any defective /malfunctioning NITECORE® product can be
To Next Page
Loading...
Need help?
General
