Using the NiTek
10 NiTek Dive Computer User Manual
Getting started
The NiTek has many modes and screens and a number of options
that can be changed depending on your dive location and profile.
The following is a checklist of general things that you should
pay attention to before, during, and after a dive.
Before a dive
• Check that the proper time and date are set. If you traveled,
your NiTek may be set to your home time zone.
• Check that the proper mix is set
• Make sure that you review the dive plan mode for maximum
depths and times for the mix you are using
During a dive
• Monitor the NiTek throughout your dive for depth and time
• Monitor the nitrogen and oxygen loading bar graphs
• Pay attention to any alarms, such as an ascent rate warning
• Follow the no-decompression limits or complete the required
decompression displayed and perform the necessary safety
stop
After a dive
• Monitor surface interval time if making another dive
• Follow the no-fly requirements
• Review your dive using the log mode and profile mode
• Download the dive log to your PC if you have the optional
PC interface
To Next Page