Nitek Dive computer - Page 37

Using the NiTek
NiTek Dive Computer User Manual 33
• If there is an error reported after the dialog box says
“transfer,” check for a loose or dirty connection between the
NiTek and the interface module.
To enter PC transfer mode:
1. Press button B.
The arrow at the bottom of the display points to LOG.
2. Press button A for five seconds.
The arrow at the bottom of the display points to PF.
3. Press buttons A and B simultaneously for five seconds.
The arrow at the bottom of the display points to TRN.
4. Transfer the dive log data to your PC.
5. When finished, press buttons A and B simultaneously for
five seconds to return to log mode.
6. Press button B for three seconds to return to surface mode.