NITEO TOOLS MLTM0037-21 - Page 41

41
7.7 Direct voltage (DC) measurement ( )
1. Connect the black measuring probe to the
socket (5), connect the red one to the socket
(4).
2. Use the measurement dial (2) to select the correct
range of DC voltage measurement ( ). If you do
not know the measurement range, rst select the
highest possible range, then switch to lower ones.
3. Connect the measuring ps to the measured part -
paraller.
4. The mulmeter will perform the measurement and
show the result on the display (a negave result will
be indicated by a minus sign before the displayed
value).
7.8 Baery test ( )
1. Connect the black measuring probe to the (5)
socket, connect the red one to the
input socket (6).
2. Depending on the tested baery, use the
measurement dial (2) to select the correct voltage
measurement range (1.5 V or 9 V) from the range of
.
3. Connect the red measuring probe to the posive
pole, connect the black one to the negave pole.
4. The mulmeter will measure the value and show the
result on the display.