To Next Page

To Previous Page

Nix Spectro 2 - 2mm

INSTRUCTIONS

For use with control strips greater or equal to 4mm diameter in print

and packaging:

1. Place your sample to measure, at on a hard surface (such as a desk)

2. Visually align your alignment jig to the center of the patch to be

measured.

3. Hold the alignment jig rmly so it doesn’t inadvertently shift.

Questions and Answers:

Need help?

Do you have a question about the NIX Spectro 2 and is the answer not in the manual?

NIX Spectro 2 Specifications

General