NIX Spectro 2 - 2 mm Model Scanning Continued

To Next Page

To Previous Page

NIX SPECTRO 2: QUICK START GUIDE

4. Place your Nix Spectro 2 – 2mm device in the alignment jig. Ensuring

proper contact with the cross pattern.

Note: You may have to rotate your Nix Spectro 2 – 2mm device slightly to allow it to seat

into the alignment jig properly.

5. Take a scan as normal.

6. Repeat steps 1-5 for the remainder of the control patches.

Note: Do not use the included alignment jig when white tile calibrating your Nix Spectro

2 – 2mm device

Note: If using the Nix Spectro 2 – 2mm while connected to USB, ensure the unit sits at as

the USB can potentially cause to tilt.

Note: If you aren’t measuring control strips. you don’t need the Spectro 2 - 2mm.