10
Set up
Charging no!no! GLOW
•Charge no!no! GLOW for 5 hours
before using it for the first time.
•Recharge no!no! GLOW after each
use until the red light on the On/Off
button stops blinking and the green
light appears.
•While charging, the On/Off button
will be red and blinking. When the
device is fully charged - the On/Off
button will be steady green.
•For safety reasons, your
no!no! GLOW will not operate while
plugged into the charger. Before
beginning treatment, unplug the
charger from the electrical outlet
and disconnect no!no! GLOW.
Before you start
•Because no!no! GLOW uses
advanced Light & Heat Energy
technology, you should feel a heat
sensation during treatment. On
rare occasions, it may become
too uncomfortable. In that case,
stop treatment and allow your skin
to cool for several minutes before
continuing.
•Use a mirror to make sure you
accurately treat the desired area.
To Next Page