The unit is designed to play normal music CD and MP3 disc bearing the correct identication logo. If the
disc does not confirm to the standard, it may not be played back properly.
Caution:
• Playback of CD-R/CD-RW may depend on recording conditions.
• Do not attach a seal or label to either side (the recordable side or the labeled side) of a CD-R/
RW disc. It may cause malfunction.
• Do not load a blank CD-R/ RW disc. It will take over 1 minute to read the disc. The disc may
be damaged if you try to open the CD Door while reading the disc.
• CD-ROM, CD-I, CDV, VCD, DVD or computer CDs are not possible to be read.
CD playback
After loading the disc, the disc will begin spinning and the total number of the tracks on the disc will
be shown on the display. Press the PLAY/PAUSE button once, the first track on the CD will
start to play.
CD & MP3 DISC OPERATION
Remark:
• If there is no disc in the unit, “No” or “Er” will be indicated on the display.
• If the CD cannot be read, “No” or “Er” will be indicated on the display.
Play/Pause Control
To pause playback temporarily press the PLAY/PAUSE button. Music playback will be paused.
The play icon will flash. Press the PLAY/PAUSE button again to resume playback.
Stop playback
To stop playback, press the STOP button on the unit. The total number of tracks of the disc will be
displayed.
Skip track
During playback, press the forward or backward SKIP buttons to skip to the next or previous tracks.
High-speed music search
During playback, press and hold the forward or backward SKIP buttons to skip/search through the
current track at high speed in forward or backward directions. When the SKIP buttons are released,
normal playback speed will be resumed immediately.
EN - 6
Loading disc
1. Press the SOURCE button to switch to CD mode with LCD shows CD icon.
2. Lift up the CD door.
3. Hold the CD disc by its edge with CD graphical side facing up and put it onto the CD compartment.
Make sure that the disc label is facing up.
4. Close the CD door.
To Next Page
Loading...