How to fix a solid hot LED on my NOCO Genius BOOST X Remote Starter?
A solid hot LED indicates the unit is fully operational but approaching its upper temperature limit. You should allow the unit to cool down.
What does a solid cold LED on my NOCO Genius BOOST X Remote Starter mean?
A solid cold LED means the unit is fully operational but approaching its lower temperature limit. Allow the unit to warm up.
Why is the hot LED on my NOCO Genius Remote Starter solid or flashing?
If the hot LED on your NOCO Genius Remote Starter is solid or flashing, it means the unit is fully operational but is getting close to its maximum temperature. To resolve this, allow the unit to cool down. If the unit is too hot to jump start, only the flashlight is available in this state. In this case, allow the unit to cool.
Why is my NOCO Genius BOOST X Remote Starter showing a solid red light?
A solid red light on your NOCO Genius Remote Starter indicates reverse polarity has been detected. To fix this, reverse the battery connections.
What does the single/double/triple/quadruple/sextuple flash mean on my NOCO Genius Remote Starter?
A series of flashes on your NOCO Genius Remote Starter can indicate several issues: a short circuit on the battery clamps. In this case, remove all loads and reconnect the clamps to the battery. It can also mean that a high voltage was detected at the clamps (the GBX75 is connected to a voltage system greater than 12V, such as 24V), a bad battery cell was detected, a charge timeout error occurred (i.e. the GBX75 has been in bulk charge for too long), or back-charge was detected into the GBX75 through the clamps while in Boost Mode (i.e. the GBX75 is in Manual Override and then connected to a system greater than 12V, such as 24V).
What to do if my NOCO Genius Remote Starter shows a solid red light?
A solid red light indicates reverse polarity has been detected. To resolve this, reverse the battery connections.
Why is the hot LED flashing on my NOCO Genius BOOST X?
A flashing hot LED means the unit is too hot to jump start. In this state, only the flashlight function is available. Allow the unit to cool down.
What to do if my NOCO Genius BOOST X is flashing red and solid red?
If you observe a flashing red light followed by a solid red light while charging the unit, inspect the charging cable or charger for any signs of damage. Also, if charging a USB-C device, check the cable or device for damage. If the connected charger is incompatible, unplug the USB cable, turn the unit off and then on, and use a different charger.
What does it mean if my NOCO Genius BOOST X Remote Starter flashes once, twice, three times, four times, or six times?
These flash patterns can indicate several issues: a short circuit on the battery clamps (remove all loads and reconnect the clamps to the battery), high voltage detected at the clamps, a bad battery cell, a charge timeout error, or back-charge detected through the clamps while in Boost Mode.
What does it mean when the cold LED is flashing on my NOCO Genius Remote Starter?
A flashing cold LED indicates the unit is too cold to jump start, and only the flashlight is available. Allow the unit to warm up.
Warns about electrical shock from device and explosion risk from incompatible or damaged batteries.
Covers fire risks, eye injury from debris, and hazards from explosive battery gases.
Instructions for initial charging, fast charging, and charging time based on charger rating.
Details on using auto chargers and power sources like USB ports and car chargers.
Procedure for correctly connecting the battery clamps to the vehicle battery terminals.
General| Brand | NOCO Genius |
|---|---|
| Model | BOOST X |
| Category | Remote Starter |
| Language | English |
To Next Page
