To Next Page

To Previous Page

Auto Charger.

The most eective way to charge GBX75 is by using The NOCO Auto Charger (not included).

NOTE: The vehicle must be On / Running for the Auto Charger to Fast Charge the unit.

Power Source.

When charging USB devices, it is important to power on the GBX75 unit ﬁrst and then plug in the USB device being charged.

NOTE: If the GBX75 unit is not powered on ﬁrst, it will drain power from the USB device, if it is DRP compatible. To charge GBX75 with a DRP compatible device

(e.g phone, laptop, power bank) ensure GBX75 is powered OFF before making a cable connection between GBX75 and the DRP device.

Step 2: Connect to the Battery.

Carefully read and understand the vehicle owner’s manual on speciﬁc precautions and recommended methods for jump starting the vehicle. Make sure to

determine the voltage and chemistry of the battery by referring to your battery owner’s manual prior to using this product. The GBX75 is for jump starting 12-volt

lead-acid batteries only. Before connecting to the battery, verify that you have a 12-volt lead-acid battery. The GBX75 is not suitable for any other type of battery.

Identify the correct polarity of the battery terminals on the battery. The positive battery terminal is typically marked by these letters or symbol (POS,P,+). The

negative battery terminal is typically marked by these letters or symbol (NEG,N,-). Do not make any connections to the carburetor, fuel lines, or thin, sheet metal

parts. The below instructions are for a negative ground system (most common). If your vehicle is a positive ground system (very uncommon), follow the below

instructions in reverse order.

1. Connect the positive (red) battery clamp to the positive (POS,P,+) battery terminal and the negative (black) battery clamp to the negative (NEG,N,-) battery

terminal or vehicle chassis.

Step 3: Jump Starting.

1. Make sure all of the vehicle’s power loads (headlights, radio, air conditioning, etc.) are turned o before attempting to jump start the vehicle.

2. Press the power button to begin jump starting, and all LEDs will ﬂash once. If you are properly connected to the battery, the white boost LED will illuminate and

the battery charge LEDs will chase. A 60-second timeout countdown will begin as soon as a battery is detected.

3. Try starting the vehicle. Most vehicles will immediately start. If the vehicle does not start right away, wait 20-30 seconds and try again. After the 60-second

timeout is complete, the unit must be powered o, then back on, to initiate a new jump-start sequence. Do not attempt more than ﬁve (5) consecutive jump

starts within a ﬁfteen (15) minute period. Allow the GBX75 to rest for ﬁfteen (15) minutes before attempting to jump start the vehicle again.

4. Once you have started your vehicle, power o the unit, disconnect the battery clamps, and remove the GBX75.

Recharge Time: Charger Rating:

1.7h

60W

Auto Charger.