NOIDS POT EXT2020 - Cleaning and Care; Instructions; Cleaning the surface

Hot appliance, BURNS HAZARD
Always leave the appliance and the parts to cool down before cleaning.
Improper use, RISK OF DAMAGE TO SURFACES
- Do not use steam jets for cleaning the appliance.
- Do not use cleaning products containing chlorine, ammonia or bleach on steel
parts or parts with metallic nishes
(e.g. anodizing, nickel- or chromium-plating).
- Do not use abrasive or corrosive detergents
(e.g. powder products, stain removers and metallic sponges).
- Do not use rough or abrasive materials or sharp metal scrapers.
To keep the surfaces in good condition, they should be cleaned regularly after use.
4.2 Cleaning the surface
4.3 Ordinary daily cleaning
Always use products that do not contain abrasives or chlorine-Based acids. Put the product onto
a damp cloth and wipe the surface, then wipe over thoroughly and dry with a soft cloth or a
microber cloth.
4.4 Food stains or residues
Do not use metallic sponges or sharp scrapers as they will damage the surfaces. Use ordinary
non-abrasive products with the aid of wooden or plastic utensils if necessary. Wipe over thor-
oughly and dry with a soft cloth or a microber cloth.
4.5 Cleaning the Glass
The Glass is machine washable.
• Dishwasher: The Glass is machine washable. Rinse rst and then put the Glass into dishwasher
- same as washing a regular glass.
• Hand wash: Rinse rst with warm water to get rid of residue. Use non-abrasive dish cleaners
and non-abrasive cloth or sponge for further cleaning.
4.6 Cleaning the Filter Set
The Filter Set is machine washable. Before washing, remove the Filter Disc from the Filter Funnel.
• Dishwasher: Rinse rst and then put the Filter Set into dishwasher. Make sure the pipe and
pipette are not horizontally placed - same as washing regular kitchen tools.
• Hand wash: Rinse rst with warm water to get rid of residue. Use non-abrasive dish cleaners
and non-abrasive cloth or sponge for further cleaning.
5. Troubleshooting
5.1 Before troubleshooting
Make sure the cooker is properly connected to power and the power is on.
5.2 What to do if ...
Beep Light Cause Solution
Cooker
doesn’t turn on
Cooker
doesn’t work
No beep
10 sec.
10 sec.
No beep
30 sec
No light
Blinks
No light
Blinks
Blinks
Damaged power cord.
The Glass is not put in the Main
Body or the Glass is not touching
the bottom sensors in the Main
Body properly
The bottom of the Glass is wet
Temperature in the Glass is too
high - protection against dry
heating
Glass is not properly covered and
the target temperature can not
be reached
Heating time for evaporation
function is too long
Thermal sensor malfunction
Component defect
Contact NOIDS distributor for
replacement. (Visit www.noids.green)
Put the Glass in the Main Body, or
press the Glass down to touch the
probes properly, then restart the
function
Dry the bottom of the Glass, then
restart the function
Let the Cooker cool down rst, then
put content in the Glass and restart
the function
Cover the Glass properly and restart
the function
Restart the function to continue evap-
oration
Restart the function by turning the
Rotary Control
Contact NOIDS for repair. (Visit www.
noids.green)
EN
8