Part
Glass
Pipette
Dish Lid
Sleeve
Sensor Pad
Lock Ball
Filter Funnel
Brush
Material
Borosilicate glass
SUS304 stainless steel
Silicone
SUS304 stainless steel
Silicone
SUS304 stainless steel
Wool
Standard compliance
XXXX
XXXX
XXXX
XXXX
3. Use
ELECTRICAL SHOCK HAZARD
- Do not use an extension cord.
- Failure to follow these instructions can result in electrical shock, re, or death.
3.1 Before first use
1. Remove all stickers and labels and clean the outside and the inner surface of the cooker with a
damp cloth.
2. Use the cooker for the rst time in Decarb function with empty Glass. In this way you will burn
off any dust that has fallen into the cooker during production or transport.
This appliance can be used safely with an input voltage between 110 and 240 V DC
and at both 50 Hz or 60 Hz without making any setting change.
During rst use some odour may develop.
User hints & tips
- This cooker is designed with optimal temperatures and time duration for the
decarboxylation and extraction of medicinal herbs. Infusing dried and ground
common kitchen spices with oil may also yield satisfactory outcomes.
3.2 Operation - General
1. If necessary, shorten the cord by wrapping it.
2. Make sure the inner surface of the Main Body and the bottom of the Glass is dry.
3. Place the Main Body on the Base with the Base Mark facing the operator.
4. Plug in the cooker. Wait till the cooker beeps and the Point LED Light is on. The cooker is now
in the initial standby mode ready to use.
It doesn’t matter which function the Base Mark is aligned to when the cooker is
connected to power. You can only activate a chosen function circle by further action
of turning the Rotary Control body.
3.3 Operation - CBD Decarb & Decarb
User hints & tips
- Differently prepared and stored plant material have different moisture content
and will require different lengths of time to reach the optimal temperature.
- Water vapour may condense on and around the Filter Disc during decarboxyla-
tion if the plant material is fresh or with high moisture content. In such case, you
can still proceed to Oil functions without drying the plant material or the Glass.
The water will evaporate during the Oil function circles.
For best results:
- Break big plant material into smaller parts before decarboxylation.
1. Put plant material into the Glass, make sure it doesn’t exceed the MAX mark on the Glass.
2. Make sure the Sleeve is positioned in the right place, then cover the Glass with the Dish Lid.
The Glass must be covered properly with the Dish Lid in order to achieve the op-
timal temperature. If the hot air escapes too fast, the sensor will never detect the
optimal temperature.
EN
5
To Next Page
Loading...