Getting started
4 Copyright © 2004 Nokia. All rights reserved.
■ Display and standby
mode
The indicators described below are
shown when the phone is ready for
use and no characters have been
keyed in by the user. The screen is
called ‘standby mode’.
1. Shows the name of the cellular
network in which the phone is
being currently used, or the
operator logo.
2. Shows the signal intensity of the
cellular network at your current
location.
3. Shows the battery charge level.
4. Shows the current function of
the Navi key .
■ Changing the covers
Before changing the cover, always
switch off the power and disconnect
the phone from the charger or any
other device. Avoid touching
electronic components while
changing the covers. Always store
and use the phone with the covers
attached.
1. Remove the back cover of the
phone and battery. See steps 1
and 2 in ”Inserting a SIM card” on
page 1.
2. Remove the front cover carefully
starting from the bottom of the
phone(3).
3. Remove the keymat carefully (4).
Press the new keymat into the
new front cover starting from the
top (5). Make sure that the new
keymat is properly positioned (6).
4. Align the top of the front cover
with the top of the phone and
press the front cover to lock it
into place (7).
5. Insert the battery and replace the
back cover on. See steps 4 and 5
in ”Inserting a SIM card” on page
1.
To Next Page
Loading...
Need help?
General
