Nokia 2600 - Messages (Menu 01)

Menu functions
16 Copyright © 2004 Nokia. All rights reserved.
■ Messages (Menu 01)
Writing a text message
You can write and send multi–part messages consisting of several
ordinary text messages (Network service). Invoicing may be based upon
the number of ordinary messages that are needed for any multi–part
message. The number of available characters/the current part number of a
multi–part message is shown on the top right of the display, for example
120/2. If you use special (Unicode) characters, more parts may be required
for the message than would otherwise be required. Note that predictive
text input may use Unicode characters.
To send a message, the phone number of your message centre has to be
saved in the phone. See "Message settings" on page 21.
1. In standby mode, press Menu and select Messages and Create
message.
2. Key in the message. The number of available characters and the
current part number are shown on the top right of the display.
3. When the message is complete, press Options, select Send, key in the
recipient’s phone number, and press OK.
If you want to send the message to several people, select Sending
options and Send to many, scroll to the first recipient, and press Send.
Repeat this for each recipient.
To send a message to a predefined distribution list, select Sending
options and Send to list.