Nokia 3230 - Starting an Application Using a Voice Command; Replaying, Erasing, or Changing a Voice Command

133Copyright © 2005 Nokia. All rights reserved.
4. After recording, the phone plays the recorded command and the note Playing
voice command is displayed. If you do not want to save the recording, press
Quit.
5. When the voice command has been successfully saved, the note Voice
command saved is displayed and a beep sounds. A symbol can be seen next
to the application.
Starting an application using a voice command
1. In standby mode, press and hold the right selection key. A short tone is played
and the note Speak now is displayed.
2. When you are starting an application by saying a voice command, hold the
phone a short distance away from your mouth and pronounce the voice
command clearly.
3. The phone plays the original voice command and starts the application. If the
phone plays an incorrect voice command, press Retry.
Replaying, erasing, or changing a voice command
To replay, erase, or change a voice command, scroll to the item that has a voice
command (indicated by ), select Options, and then either:
• Playback - Listen to the voice command again.
• Delete - Erase the voice command.
• Change - Record a new voice command. Press Start to record.