446F
9
1.5. Monitor Connection
Make sure that the monitor is disconnected from mains and the power switches of
the computer and all attached devices are turned off before connecting the monitor.
-- Connect the signal cable plug to the videocontroller connector at the back of the computer.
-- Tighten the screws on the plug by hand.
-- Connect the power cord first to the monitor and then to a grounded power outlet.
If your computer is DDC compatible (PC)
-- Do not use any adapter when connecting signal cable to your computer.
-- Do not extend t he signal cable with extension lead. The DDC signals will not accept extended
cable.
--- Display controller must be compatible for External +5 V
Signal connector
Pin Signal
1 -- >RV Redvideo
2 -- > GV Green video
3 -- > BV Blue video
4<-- N.C
5 Plugged / unplugged test
6 RG Red ground
7 GG Green ground
8 BG Blue ground
9 -- > DDC +5V (optional)
10 LG Logic Gnd
11 <-- ID0 ID0 (tied to LG)
12 <-- DDC SDA
13 -- > Hs Horizontal synchronization, composite sync
14 -- > Vs Vertical synchronization
15 <-- DDC SCL
1 5
6 1011 15
To Next Page
Loading...
