25
7-5.1. GEOMETRIC ADJUST
a. Press the MENU key to reveal the OSM, then using either the+key or -key to choose the geometric
adjustment.( SHAPE as shown on OSD )
b. Selecting the item which needs to be adjusted in the submenu disposed on the lower part of the OSM
c. Press the MENU key again, the OSM will address to exhibit the adjustment bar.
d. Press either+key or-key to change the magnitude of the setting until the optimized picture is obtained.
ICON NAME FUNCTION
Horizontal position To adjust the horizontal position of the display
Horizontal size To adjust the width of the display
Vertical position To adjust the vertical position of the display
Vertical size To adjust the height of the display
Pincushion To adjust any tapering or bowing of the
sides.
Trapezoid To adjust the top and bottom of the image to the same
size
Rotation To adjust the display tilt
To enable the OSD
menu to be moved horizontally.
Side Pin Balance To straighten the left or right side of the image.
(Only at preset OSD menu)
Parallelogram To square the image.
Degauss To degauss the display
Monitor Defaults To recall the original factory display settings or save
otherwise.
Exit Menu To remove the OSD menu
Language Changes the language display on OSM as require
To Next Page
Loading...
