26
7-6. Focus Adjust
a) Apply a 69 kHz signal with cross-hatch pattern.
b) Adjust FOCUS adjust on T440 to get the best overall focus.
7-7. Convergence Adjustment
Note 1: For a unit with new ITC, adjustment for convergence may not be necessary.
2: Prior to the convergence alignment the another adjustment procedures must be completed.
a) Apply a VGA signal with full-white pattern to the unit.
b) Turn brightness control to center detects.
c) Use a photometer to set the screen center brightness up to 20 FL by adjusting the contrast
control.
d) Apply a VGA signal with crosshatch pattern to the unit.
e) Loosen the convergence magnet ring with a screwdriver.
f) Converge the red and blue lines at the center of screen by rotation the two tabs of the 4 poles
static convergence magnet.
g) Tighten the convergence magnet lock ring with a screwdriver.
To Next Page
Loading...
