[ 72 ]
3 Write down your interaction with the recorded prompts step-by-step.
Keep in mind that each voicemail service may vary. However, it should
look something like this:
Dial 2145551212, pause 5 seconds, press 1, pause 2 seconds, press
1234, press pound key.
Important: Be precise, you’ll need this information in “Setup
voicemail with dialing codes” later in this section.
LEARN HOW TO INSERT DIALING CODES
Press
a repeatedly to cycle through dialing codes. Once the desired code
appears in the display, pause briefly and the code is inserted into the
dialing string.
For example, press a four times to display the “w” (wait character). Pause
briefly and the wait character is inserted into the dialing string. Available
dialing codes are as follows:
Setup voicemail with dialing codes
1 At the Start screen, press Names, scroll to 1-touch dialing, and
press Select.
2 Scroll to an empty 1-touch dialing slot and press Assign.
3 Enter your voice mailbox number, including the area code.
4 Refer to the table entitled “dialing codes,” and enter any codes as
necessary using the information that you wrote down earlier.
For example, if you pause for 5 seconds after connecting to voicemail,
Dialing codes
*
Bypasses a set of instructions
+ Precedes an international telephone number
p Pauses for 2.5 seconds before sending any numbers that follow
w Wait. Your phone waits for you to press t before it sends any
numbers or codes that follow.
To Next Page
Loading...
