7368 ISAM ONT BGW320-505 Product Guide Install an BGW320-505 indoor ONT
Issue: 01 3FE-47753-AAAA-TCZZA 37
4.5 Procedure
Use this procedure to install an BGW320-505 indoor ONT.
1 Place the indoor ONT unit on a flat surface, such as a desk or shelf.
2 Review the connection locations, as shown in Figure 5.
Note — The BGW320-505 ONT cannot be stacked with another ONT
or with other equipment. The ONT mounting requirements are:
• place the unit in a vertical upright position with the feet and grill facing
down and the flat top facing up
• allow a minimum 100 mm clearance above the top cover
• do not place any heat source directly above the top cover or below the
bottom cover
Warning — There is a risk of overheating if the BGW320 is not properly
ventilated. The unit should not be placed in an enclosed cabinet or
location without proper ventilation.
Make sure the temperature requirement described in Section 3.6 are
adhered to.
Release 06.02.00b | October 2019 | Edition 01
To Next Page
Loading...
