Copyright © 2004 Nokia. All rights reserved.
Your phone
20
Answering a call
• To answer an incoming call, press .
• To end the call, press .
If you do not want to answer a call, press . The caller will hear a ’line busy’ tone.
When a call comes in, press Silence to quickly mute the ringing tone.
Options during a call
Press Options during a call for some of the following options:
Mute or Unmute, End active call, End all calls, Hold or Unhold, New call, Conference,
Private, Drop participant, Answer, and Reject.
Swap is used to switch between the active call and the call on hold.
Transfer is used to connect an incoming call or a call on hold with an active call and to
disconnect yourself from both calls.
Send DTMF is used to send DTMF tone sequences, for example, passwords or bank account
numbers.
You may not have all of these options. Contact your service provider for more details.
1 Key in the digits with - . Each keystroke generates a DTMF tone, which
is transmitted while the call is active. Press repeatedly to produce: *, p (inserts
a pause of approximately two seconds before, or between DTMF characters.), and w
(if you use this character, the remaining sequence is not sent until you press Send
again during the call). Press to produce #.
2 To send the tone, press OK.
Fig. 7 Options during a
call.
To Next Page
Loading...
