Define Internet connections
25
Copyright © 2006 Nokia. All rights reserved.
have not saved any connections or they are unavailable, you are asked
to select the connection (Internet access point) you want to use.
In the Select connection dialog, select a connection from the list, and
tap Connect. Only available connections are shown, and the
connections you have saved in your device appear at the top of the list.
To define the settings of Internet connections and access points, tap ,
and select Tools > Control panel > Connectivity.
On the General page, define the following settings:
Connect without asking — Select which connections are used without
asking when connection is needed. This setting applies only to networks
and connections you have saved in your device.
On the Idle times page, select the time after which the Internet
connection ends automatically if the connection is not used. Use
Packet data idle time for packet-switched data connections (such as
GPRS), Data call idle time for circuit-switched data calls (such as GSM
data call), and WLAN idle time for connections created through a WLAN
access point.
Note: Time-based charges may apply to the Internet
connections. Check with your service provider, and adjust the
idle times accordingly.
Note: The network may also have idle timers that may cause
the Internet connection to break, regardless of the idle timers of
the device.
Disable Internet connections
To disable WLAN and Bluetooth connections, briefly press the power
key, select Offline mode, and tap OK. To enable connections, briefly
press the power key, select Normal mode, and tap OK.
Note: In the offline mode, you cannot use features that require
network or Bluetooth connection. To use the features, you must
first set the device back to normal mode. If the device has been
locked, enter the lock code.
To Next Page
Loading...
Need help?
General
