Call functions
Copyright © 2007 Nokia. All rights reserved. 22
If you are using a compatible headset
with the headset key, press and hold
the headset key to start the voice
dialling.
2. Say the voice command clearly. If the
voice recognition is successful, a list
with matches is shown. The phone
plays the voice command of the
match on the top of the list. After
about 1.5 seconds, the phone dials
the number. If the result is not the
correct one, scroll to another entry,
and select to dial the entry.
Using voice commands to carry out a
selected phone function is similar to
voice dialling. See Voice commands in
“My shortcuts”, p. 51.
■ Answer or reject a call
To answer an incoming call, press the call
key, or open the phone. To end the call,
press the end key or close the phone.
To reject an incoming call, press the end
key, or select Silence > Reject.
To mute the ringing tone, select Silence.
Tip: If the Divert if busy function
is activated to divert the calls (for
example, to your voice mailbox),
rejecting an incoming call also
diverts the call. See “Call”, p. 56.
If a compatible headset supplied with the
headset key is connected to the phone, to
answer and end a call, press the headset
key.
Call waiting
To answer the waiting call during an
active call, press the call key. The first call
is put on hold. To end the active call,
press the end key.
To activate the Call waiting function,
see “Call”, p. 56.
■ Options during a call
Many of the options that you can use
during a call are network services.
For availability, contact your service
provider.
During a call, select Options and from
the following options:
Call options are Mute or Unmute,
Contacts, Menu, Lock keypad, Record,
Loudspeaker or Handset.
Network services options are Answer or
Reject, Hold or Unhold, New call, Add to
conference, End call, End all calls, and the
following:
Send DTMF—to send tone strings
Swap—to switch between the active call
and the call on hold
To Next Page
Loading...
