ENGLISH
To allow the headset to connect to
two devices, switch off the headset,
and press and hold the power key, and
slide and hold the volume key up for
about 5 seconds. The green indicator
light flashes once.
To allow the headset to connect to
two devices, switch off the headset,
and press and hold the power key, and
slide and hold the volume key up for
about 5 seconds. The yellow indicator
light flashes once.
If the headset can connect to two
devices at the same time and you use
redialing or voice dialing, the call is
made on the device that you last used
to make a call when the headset was
connected to it.
Clear settings or reset
To clear all the settings from the
headset (including settings you have
defined with the Nokia Accessory
Setup Application), switch off the
headset, and press and hold the power
key and the answer/end key at the
same time for about 8 seconds. The
headset beeps twice, and the red and
green indicator lights alternate. After
the settings are cleared, the headset
enters pairing mode.
To reset the headset if it stops
functioning, even though it is charged,
connect the headset to a charger
while you press and hold the
power key.
Troubleshooting
If you cannot connect the headset to
your compatible device, check that
the headset is charged, switched on,
and paired with the device.
9218881_EN-US_1.fm Page 10 Friday, September 11, 2009 6:01 PM
To Next Page
Loading...
