Basic use
15
■ Listen to music
To listen to music, pair and connect the headset to a device
that supports the A2DP Bluetooth profile (see “Pair the
headset,” p. 11). To play music, use the playback controls on
the connected device.
If you answer or make a call while listening to music, the
music is paused until you end the call.
■ Clear settings or reset
To clear the headset settings, switch off the headset, and
press and hold the multifunction key for at least 8 seconds.
To reset the headset if it stops functioning, even though it is
charged, plug the headset into a charger while you press
and hold the multifunction key.
■ Troubleshooting
If you cannot connect the headset to your compatible
device, check that the headset is charged, switched on, and
paired with the device.
To Next Page
Loading...
