To create a new server profile, select Options > Server profiles > Options > New
server profile.
You may receive these settings from your service provider in a configuration
message. If not, define the following:
Server name — Enter a name for the configuration server.
Server ID — Enter the unique ID to identify the configuration server.
Server password — Enter a password to identify your device to the server.
Access point — Select the access point to use for the connection, or create a new
access point. You can also choose to be asked for the access point every time you
start a connection. This setting is available only if you have selected Internet as the
bearer type.
Host address — Enter the web address of the configuration server.
Port — Enter the port number of the server.
User name and Password — Enter your user ID and password for the configuration
server.
Allow configuration — Select Yes to allow the server to initiate a configuration
session.
Network authentication — Select whether to use HTTP authentication.
Network user name and Network password — Enter your user ID and password for
HTTP authentication. This setting is available only if you have selected Network
authentication to be used.
To connect to the server and receive configuration settings for your device, select
Options > Start configuration.
To view the configuration log of the selected profile, select Options > View log.
To update the device software over the air, select Options > Check for updates. The
update does not erase your settings. When you receive the update package on your
device, follow the instructions on the display. Your device is restarted once the
installation is complete.
Warning:
If you install a software update, you cannot use the device, even to make emergency
calls, until the installation is completed and the device is restarted.
98 Data management
To Next Page
Loading...
