This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. See 47 CFR Sec. 15.105(b).
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) This device may not cause interference and (2) This device must
accept any interference, including interference that may cause undesired operation of the device.
See RSS-Gen, Section 8.4. This device complies with ICES-003 requirements for Class B ITE
(Information Technology Equipment). CAN ICES-3 (B)/NMB-3(B) This device meets the IC
requirements.
Industry Canada notice to users
(2) This device must accept any interference received, including interference that may cause
undesired operation. See 47 CFR Sec. 15.19(a)(3). HMD Global has not approved any changes or
modification to this device by the user. Any changes or modification could void the user’s authority
to operate the equipment. See 47 CFR Sec. 15.21
ثﻮﺗﻮﻠﺒﻟﺎﺑ ﻞﻴﺻﻮﺘﻟاو ناﺮﺘﻗﻹا .٢
زﺎﻬﺠﻟا ﻊﻣ ناﺮﺘﻗﻻا ٢.١
ناﺮﺘﻗﻻاو ﻞﻴﻐﺸﻟا -أ ٢.١
.ﺎ
ً
ﻴﺋﺎﻘﻠﺗ ﺾﻌﺒﻟا ﺎﻬﻀﻌﺑ ﻊﻣ ﺎﻬﻧاﺮﻗإو نذﻷا تﺎﻋﺎﻤﺳ ﻞﻴﻐﺸ½ ﻢﺘﺳ ،ﻦﺤﺸﻟا ﺔﺒﻠﻋ ﻦﻣ نذﻷا تﺎﻋﺎﻤﺳ جاﺮﺧإ ﺪﻨﻋ
ﺮﻤﺣﻷاو قرزﻷا ﻦﻴﻧﻮﻠﻟﺎﺑ ﻰﻨﻤﻴﻟا نذﻷا ﺔﻋﺎﻤﺴ® صﺎﺨﻟا LED ﺮﺷﺆﻣ ءﻮﺿ ﺾﻣﻮﻴﺳ ،حﺎﺠﻨﺑ ناﺮﺘﻗﻻا ﻢﺘﻳ ﺎﻣﺪﻨﻋ
.ﻚﺑ صﺎﺨﻟا ثﻮﺗﻮﻠﺒﻟا زﺎﻬﺟ ﻊﻣ ﻞﻴﺻﻮﺘﻠﻟ ةﺰﻫﺎﺟ نذﻷا تﺎﻋﺎﻤﺳ نﻮﻜﺗ ﻚﻟﺬﺑو بوﺎﻨﺘﻟﺎﺑ
ﺔﻤﺋﺎﻗ ﻦﻣ Nokia TWS-122 :ﺮﺘﺧاو كزﺎﻬﺟ ª« ثﻮﺗﻮﻠﺒﻟا ﻞﻴﻐﺸﺑ ﻢﻗ :ﻚﺑ صﺎﺨﻟا ثﻮﺗﻮﻠﺒﻟا زﺎﻬﺠﺑ لﺎﺼﺗﻻا -ب ٢.١
.لﺎﺼﺗﻼﻟ Bluetooth
ﺮﻤﺣﻷاو قرزﻷا ﻦﻴﻧﻮﻠﻟﺎﺑ ﻰﻨﻤﻴﻟا نذﻷا ﺔﻋﺎﻤﺳ ﻰﻠﻋ دﻮﺟﻮﻤﻟا LED ﺮﺷﺆﻣ ءﻮﺿ ﺾﻣﻮﻴﺳ ،ﻞﻴﺻﻮﺘﻟا ﺔﻴﻠﻤﻋ ءﺎﻨﺛأ
.بوﺎﻨﺘﻟﺎﺑ
ﻊﻣ حﺎﺠﻨﺑ ﺎﻬﻠﻴﺻﻮﺗ ﻢﺘﻳ ﺎﻣﺪﻨﻋ
ٍ
ناﻮﺛ 10 ﻞﻛ قرزﻷا نﻮﻠﻟﺎﺑ نذﻷا تﺎﻋﺎﻤﺴ® ﺔﺻﺎﺨﻟا LED ﺮﺷﺆﻣ ءاﻮﺿأ ﺾﻣﻮﺘﺳ
.ثﻮﺗﻮﻠﺒﻟا
ﻦﺤﺸﻟا ﺔﺒﻠﻋ ﻦﻣ ﺎﻬﺟاﺮﺧإ ﺪﻨﻋ Bluetooth زﺎﻬﺠﺑ ﺎ
ً
ﻴﺋﺎﻘﻠﺗ نذﻷا تﺎﻋﺎﻤﺳ ﻞﺼﺘﺳ ،ªÇوﻷا ناﺮﺘﻗﻻا ﺪﻌﺑ ٢.٢
ﻖﺋﺎﻗد 5 نﻮﻀﻏ ª« ثﻮﺗﻮﻠﺑ لﺎﺼﺗا كﺎﻨﻫ ﻦﻜﻳ ﻢﻟ اذإ ﺎ
ً
ﻴﺋﺎﻘﻠﺗ نذﻷا تﺎﻋﺎﻤﺳ ﻞﻴﻐﺸ½ فﺎﻘﻳإ ﻢﺘﺳ ٢.٣
ﺔﻴﻓﺎﺿإ ﻢﻜﺤﺗ ﺮﺻﺎﻨﻋ .٤
ةﺪﺣاو نذأ ﺔﻋﺎﻤﺳ ماﺪﺨﺘﺳا .٤.١
ªÇوﻷا ناﺮﺘﻗﻻا ﺪﻌﺑ ﺔﻳدﺎﺣأ سأر ﺔﻋﺎﻤﺴﻛ ﻰﻨﻤﻴﻟا وأ ىﺮﺴﻟا ﺔﻋﺎﻤﺴﻟا ماﺪﺨﺘﺳا ﻚﻨﻜﻤﻳ
:ﺔﻴﻠﺻﻷا تاداﺪﻋﻹا ÌÇإ ﻦﻴﻴﻌﺘﻟا ةدﺎﻋإ ٤.٢
.ﻦﺤﺸﻟا ﺔﺒﻠﻋ ª« نذﻷا ﻲ
َ
ﺘﻋﺎﻤﺳ ﻊﺿ (i
.ﺎ
ً
ﻌﻳﺮﺳ تاﺮﻣ 4 ﺔﻋﺎﻤﺳ ﻞﻛ ﻰﻠﻋ ﻂﻐﺿا (ii
.نﻵا ﻦﻴﻴﻌﺘﻟا ةدﺎﻋإ ﺖﻤﺗ ﺪﻗ نﻮﻜﺗو ªÑاﻮﺟرﻷا نﻮﻠﻟا ÌÇإ ﺮﺷﺆﻤﻟا ل
ّ
ﻮﺤﺘﺳ (iii
Що в коробці Огляд товару
1. Вступ
1.1 Перед тим, як почати використовувати навушники Nokia Go Earbuds2 Pro,
зніміть захисну плівку з навушників та помістіть навушники назад в зарядний
чохол, потім підключіть кабель для зарядки з роз'ємом USB Type-C до
джерела електроживлення для початку зарядки, повністю зарядіть
навушники та зарядний чохол перед першим використанням.
• зарядний чохол
• навушники (L/R)
• силіконові амбушюри (S/M/L)
• Зарядний кабель з
роз'ємом для USB type-C
• Стисла вступна інструкція
Зарядний чохол
Зарядні контакти (L)
Зарядні контакти (R)
Кнопка зарядного кейса
Світлодіоди стану батареї
USB-порт з роз'ємом
Type-C
Навушники
Насадка для
навушників
Сенсорне керування
Мікрофон
3
4
5
6
7
8
UA
9
To Next Page
Loading...
Need help?
General