Installation
41
When installing the display, ensure that it does not interfere with or
hinder the steering or braking systems or other controls or systems used
in the operation of the vehicle (for example, airbags).
Ensure that the display cable reaches to the hands-free unit for
connection. Mount the display on the dashboard in the upright position.
When you peel off the protective sheet from the supplied adhesive, do
not touch the adhesive with a finger.
Mount the stand to the dashboard
To use the display with the supplied stand:
1. Peel off the protective sheet from a side of the supplied adhesive,
and attach it to the feet of the stand.
2. Place the display cable between the two feet of the stand, and lock it
in place between the teeth of the feet.
3. Peel off the protective sheet from the other side of the adhesive, and
press the stand firmly to the dashboard.
Ensure that the surface where you attach the stand is dry and free from
dirt and dust.
Mount the plate to the dashboard
To use the display with the supplied mounting plate:
1. Peel off the protective sheet from a side of the adhesive, and attach
it to the plate.
2. Peel off the protective sheet from the other side of the adhesive, and
press the plate firmly to a mounting device (such as a mounting
bracket) that is attached to the dashboard.
When you use screws instead of adhesives to install the plate, do not use
screws if you mount it within the head impact area. To drill the bore
holes, check the markings on the inner side of the plate that show where
the screws can be placed.
Attach the display to the stand or plate
To attach the display to the stand:
1. Press the ball hinge on the stand into the socket on the connector
part of the display cable (1).
To Next Page
Loading...
