Nokia IP130 - Security Appliance - Packet Data Access Points

provider, and you may not be able to change, create,
edit, or remove them.
indicates a protected access point.
indicates a packet data access point.
indicates a WLAN access point.
Tip: You can create internet access points in
a wireless LAN with the WLAN wizard.
To create a new access point, select Options >
New access point.
To edit the settings of an access point, select
Options > Edit. Follow the instructions from your
service provider.
● Connection name — Enter a descriptive name
for the connection.
● Data bearer — Select the data connection type.
Depending on the data connection you select, only
certain setting fields are available. Fill in all fields
marked with Must be defined or with a red
asterisk. Other fields can be left empty, unless you
have been instructed otherwise by your service
provider.
To be able to use a data connection, your service
provider must support this feature, and if necessary,
activate it for your SIM card.
Packet data access points
Press , and select Tools > Settings >
Connection > Access points > Options > Edit
or New access point.
Follow the instructions from your service provider.
● Access point name — You obtain the access
point name from your service provider.
● User name — The user name may be needed to
make a data connection, and is usually provided
by the service provider.
● Prompt password — If you must enter the
password every time you log in to a server, or if
you do not want to save your password in the
device, select Yes.
● Password — A password may be needed to
make a data connection and is usually provided
by the service provider.
● Authentication — Select Secure to always send
your password encrypted or Normal to send
your password encrypted when possible.
● Homepage — Depending on the access point
you are setting up, enter the web address or the
address of the multimedia messaging centre.
Select Options > Advanced settings to change
the following settings:
● Network type — Select the internet protocol
type to transfer data to and from your device. The
157
Settings