Nokia IP130 - Security Appliance - WLAN Internet Access Points

other settings depend on the selected network
type.
● Phone IP address (for IPV4 only) — Enter the IP
address of your device.
● DNS address — Enter the IP addresses of the
primary and secondary DNS servers, if required
by your service provider. Contact your internet
service provider to obtain these addresses.
● Proxy server address — Enter the address of
the proxy server.
● Proxy port number — Enter the port number
of the proxy server.
WLAN internet access points
Press , and select Tools > Settings >
Connection > Access points > Options > Edit
or New access point.
Follow the instructions from the WLAN service
provider.
● WLAN network name — Select Enter
manually or Search for networks. If you select
an existing network, WLAN network mode and
WLAN security mode are determined by the
settings of its access point device.
● Network status — Define whether the network
name is displayed.
● WLAN network mode — Select Ad-hoc to
create an ad hoc network and to allow devices to
send and receive data directly; a WLAN access
point device is not needed. In an ad hoc network,
all devices must use the same WLAN network
name.
● WLAN security mode — Select the encryption
used: WEP, 802.1x (not for ad hoc networks), or
WPA/WPA2. If you select Open network, no
encryption is used. The WEP, 802.1x, and WPA
functions can be used only if the network
supports them.
To enter the settings for the selected security mode,
select WLAN security settings.
Security settings for WEP
● WEP key in use — Select the wired equivalent
privacy (WEP) key number. You can create up to
four WEP keys. The same settings must be
entered on the WLAN access point device.
● Authentication type — Select Open or
Shared for the authentication type between
your device and the WLAN access point device.
● WEP key settings — Enter WEP encryption
(length of the key), WEP key format (ASCII or
Hexadecimal), and WEP key (the WEP key data
in the selected format).
Security settings for 802.1x and WPA/WPA2
● WPA/WPA2 — Select the means of
authentication: EAP to use an extensible
158
Settings