GB 20
FIRST TIME INSTALLATION
....and you will get the Channel Search menu.
The most common is to start from the “Automatic Search” line.
(You can always make a Manual or Advanced Search later on.)
• Select ASTRA on the Automatic Search line
• Press OK......
.......and you get the Antenna Adjustment menu.
• If necessary, adjust the motor until the Signal Strength (AGC)
is optimal. Please note, that this will only affect the present
satellite position.
• Select one of the Predefined Channels and press OK.....
.....and you get a menu from where you can check the Signal
Quality (SNR) from the predefined channels. You must wait until
the picture appears that sometimes may take up to 10-15 sec-
onds.
• If necessary, adjust the motor until the Signal Quality (SNR) is
optimal. Please note, that this will only affect the present sat-
ellite position.
• Press OK to.....
.....start the main search procedure for (in this case) the ASTRA
channels. The search procedure will take a while. Please refer to
page 22.
To Next Page
Loading...
