Copyright
©
2006 Nokia. All rights reserved.
Make calls
24
• Ensure that both the sender and recipient are
registered to the UTMS network. If you invite someone
to a sharing session and the recipient’s device is
turned off, is not within UMTS network coverage, or
does not have Video sharing installed or person-to-
person connections set up, the recipient does not
know that you are sending an invitation. However, you
receive an error message that the recipient cannot
accept the invitation.
Settings
Person-to-person connection settings
A person-to-person connection is also known as a Session
Initiation Protocol (SIP) connection. The SIP profile
settings must be configured in your device before you can
use Video sharing. Setting up a SIP profile allows you to
establish a live person-to-person connection to another
compatible device. The SIP profile must also be
established to receive a sharing session.
Ask your network operator or service provider for the SIP
profile settings, and save them in your device. Your
network operator or service provider may send you the
settings over the air or give you a list of the needed
parameters.
If you know a recipient’s SIP address, you can enter it on
your contact card for that person. Open Contacts from
your device main menu, and open the contact card (or start
a new card for that person). Select Options > Add detail
> Web address. Enter the SIP address in the format
sip:username@domainname (you can use an IP address
instead of a domain name).
Share live video and video clips
To receive a sharing session, the recipient must install
Video sharing and configure the required settings on their
mobile device. You and the recipient must both be
registered to the service before you can start sharing.
1 Select Options > Share video > Live or Clip.
If you selected Clip, a list of video clips opens. Select a
video clip you want to share and Options > Send
invitation.
2 Select the SIP address of the recipient to which you
want to send the invitation from the contacts list.
If the SIP address of the recipient is not available, enter
a SIP address.
3 Sharing begins automatically when the recipient
accepts the invitation.
4 Select Pause to pause the sharing session. Select
Continue to resume sharing. If sharing a video clip, you
can rewind and fast forward the clip.
5 To end video sharing, select Stop or close the camera
slider. Video sharing also ends if the active voice call
ends.
To Next Page
Loading...
