Nokia N71 - Page 91

Copyright
©
2006 Nokia. All rights reserved.
Tools
82
Reject call with SMS — To send a text message to a caller
informing why you could not answer the call, select Yes.
See "Answer or reject a call", on page 47.
Message text — Write a text to be sent in a text message
when you reject a call.
Image in video call — You can deny video sending when
you receive a video call. Select a still image to be
displayed instead of video.
Automatic redial — To set your device to make a
maximum of 10 attempts to connect the call after an
unsuccessful call attempt. To stop automatic redialing,
press .
Summary after call — Activate this setting if you want
the device to briefly display the approximate duration of
the last call.
Speed dialling — To dial numbers assigned to the speed
dialing keys ( — ) press and hold the key. See also
"Speed dial a phone number", on page 42.
Anykey answer — To answer an incoming call, by pressing
any key except , , , and , select On.
Line in use — This setting (network service) is shown only
if the SIM card supports two subscriber numbers, that is,
two phone lines. Select which phone line you want to use
for making calls and sending text messages. Calls on both
lines can be answered irrespective of the selected line. If
you select Line 2 and have not subscribed to this network
service, you will not be able to make calls. When line 2 is
selected, is shown in the standby mode.
Tip! To switch between the phone lines, press and
hold in the standby mode.
Line change — To prevent line selection (network service),
select Disable if supported by your SIM card. To change
this setting, you need the PIN2 code.
Answer if fold opened — Select On to answer calls by
opening the cover.
Connection
Data connections and access points
Your device supports packet data connections, such as
GPRS in the GSM network. When you use your device in
GSM and UMTS networks, multiple data connections can
be active at the same time, and access points can share a
data connection.
To establish a data connection, an access point is required.
You can define different kinds of access points:
• MMS access point to send and receive multimedia
messages
• Access point for the Services application to view WML
or XHTML pages
9243184_N71-1_en_apac.book Page 82 Friday, May 26, 2006 2:31 PM