Make calls
113
mode, select Options > Continue. See ‘Active standby’, 
p. 103.
Accept an invitation
When someone sends you a share invitation, an invitation 
message is displayed showing the sender’s name or SIP 
address. If your device is not set to Silent, it rings when 
you receive an invitation.
If someone sends you a share invitation and you are not 
within UMTS network coverage,  you will not know that 
you received an invitation.
When you receive an invitation, select from the following:
Accept—to activate the sharing session.
Reject—to decline the invitation. The sender receives a 
message that you rejected the invitation. You can also 
press the end key to decline the sharing session and 
disconnect the voice call.
When you are receiving a video clip, to mute the sound of 
the clip, select Mute.
To end video sharing, select Stop. Video sharing also ends 
if the active voice call ends.
Answer or decline a call
To answer the call, press the call key, or open the slide.
To mute the ringing tone when a call comes in, select 
Silence.
If you do not want to answer a call, press the end key. If 
you have activated the Call forward > If busy function to 
divert calls, declining an incoming call also diverts the call. 
See ‘Call divert’, p. 123.
When you select Decline to reject an incoming call, you 
can send a text message informing the caller that you 
cannot answer the call. Select Options > Send text 
message. To set up this option and write a standard text 
message, see ‘Call’, p. 122.
Answer or reject a video call
When a video call arrives,   is displayed. 
Press the call key to answer the video call. Allow video 
image to be sent to caller? is displayed. To start sending 
a live video image, select Yes.
If you do not activate the video call, video sending is not 
activated, and you only hear the sound of the caller. A grey 
screen replaces the video image. 
To replace the grey screen with a still image captured by 
the camera in your device, see ‘Call’, Image in video call, 
p. 122.
To end the video call, press the end key.