6
Switch the device on
1 Press and hold the power key.
2 If the device asks for a (U)PIN
code or lock code, enter it, and
press the left selection key.
The factory setting for the lock
code is 12345.
Your device has internal antennas.
Note: As with any radio
transmitting device, avoid
touching an antenna unnecessarily when the
antenna is in use. For example, avoid touching the
cellular antenna during a phone call. Contact with a
transmitting or receiving antenna affects the quality
of the radio communication, may cause the device to
operate at a higher power level than otherwise
needed, and may reduce the battery life.
1 Cellular antenna
2 Bluetooth
technology/wireless
LAN antenna
3 GPS receiver
Charge the battery
1 Connect a compatible
charger to a wall outlet.
2 Connect the power cord
to the device. If the
battery is completely
discharged, it may take a
while before the charging
indicator starts scrolling.
3 When the battery is fully
charged, the charging indicator stops scrolling.
Disconnect the charger from the device, then from
the wall outlet.
Tip: Disconnect the charger from the wall outlet
when the charger is not in use. A charger that is
connected to the outlet consumes power even
when it is not connected to the device.
To Next Page
Loading...
