Nokia 8210 4G User Guide
Do not connect to products that create an output signal, as this may damage the device. Do
not connect any voltage source to the audio connector. If you connect an external device
or headset, other than those approved for use with this device, to the audio connector, pay
special attention to volume levels. Parts of the device are magnetic. Metallic materials may be
attracted to the device. Do not place credit cards or other magnetic storage media near the
device, because information stored on them may be erased.
Some of the accessories mentioned in this user guide, such as chargers, headsets, or data
cables, may be sold separately.
Note: You can set the phone to ask for a security code to protect your privacy and personal
data. The pre-set code is 12345. To change the code, select Menu > Settings > Security >
Keyguard > Security code , enter the new code, verify it and select OK . Note, however, that
you need to remember the code, as HMD Global is not able to open or bypass it.
SET UP AND SWITCH ON YOUR PHONE
Nano-SIM
Important: This device is designed to be used with a nano-SIM card (see figure) only. Use of
incompatible SIM cards may damage the card or the device, and may corrupt data stored on
the card.
Note: Switch the device off and disconnect the charger and any other device before removing
any covers. Avoid touching electronic components while changing any covers. Always store
and use the device with any covers attached.
© 2022 HMD Global Oy. All rights reserved. 6
To Next Page
Loading...
Need help?
General
