FCC Notice to users
The following statement applies to all products that bear the FCC logo and/or FCC
ID on the product label.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. See 47 CFR Sec. 15.105(b).
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a different circuit from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause
interference and (2) This device must accept any interference, including interference
that may cause undesired operation of the device. See RSS-Gen, Section 8.4. This
device complies with ICES-003 requirements for Class B ITE (Information Technology
Equipment). CAN ICES-3 (B)/NMB-3(B) This device meets the IC requirements.
Industry Canada notice to users
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation. See 47 CFR Sec. 15.19(a)(3). HMD Global has not
approved any changes or modification to this device by the user. Any changes or
modification could void the user’s authority to operate the equipment. See 47 CFR
Sec. 15.21
12
To Next Page
Loading...