distance instructions until the transmission is
completed.
Vehicles
Radio signals may affect improperly installed
or inadequately shielded electronic systems in
motor vehicles such as electronic fuel
injection, electronic antilock braking,
electronic speed control, and air bag systems.
For more information, check with the
manufacturer of your vehicle or its equipment.
Only qualified personnel should install the
device in a vehicle. Faulty installation or
service may be dangerous and may invalidate
your warranty. Check regularly that all
wireless device equipment in your vehicle is
mounted and operating properly. Do not store
or carry flammable liquids, gases, or explosive
materials in the same compartment as the
device, its parts, or accessories. Remember
that air bags inflate with great force. Do not
place your device or accessories in the air bag
deployment area.
Potentially explosive environments
Switch off your device in any area with a
potentially explosive atmosphere, for
example near gas pumps at service stations.
Sparks in such areas could cause an explosion
or fire resulting in bodily injury or death.
Observe restrictions in fuel service stations,
storage, and distribution areas; chemical
plants; or where blasting operations are in
progress. Areas with a potentially explosive
atmosphere are often, but not always, clearly
marked. They include areas where you would
be advised to turn off your vehicle engine,
below deck on boats, chemical transfer or
storage facilities and where the air contains
chemicals or particles such as grain, dust, or
metal powders. You should check with the
manufacturers of vehicles using liquefied
petroleum gas (such as propane or butane) to
determine if this device can be safely used in
their vicinity.
Certification information (SAR)
This mobile device meets guidelines for
exposure to radio waves.
Your mobile device is a radio transmitter and
receiver. It is designed not to exceed the limits
for exposure to radio waves recommended by
international guidelines. These guidelines
were developed by the independent scientific
organisation ICNIRP and include safety
margins designed to assure the protection of
all persons, regardless of age and health.
The exposure guidelines for mobile devices
employ a unit of measurement known as the
Specific Absorption Rate or SAR. The SAR limit
stated in the ICNIRP guidelines is 2.0 watts/
kilogram (W/kg) averaged over 10 grams of
tissue. Tests for SAR are conducted using
standard operating positions with the device
transmitting at its highest certified power
level in all tested frequency bands. The actual
SAR level of an operating device can be below
the maximum value because the device is
designed to use only the power required to
reach the network. That amount changes
depending on a number of factors such as how
close you are to a network base station.
Cyan
Magenta
Yellow
Black
To Next Page
Loading...
Need help?
General
Weight and Dimensions
