EasyManuals Logo

Nokta Velox One User Manual

Default Icon
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
MINERAL MODES
Mineral Modes: If you are searchng on hgh mneralzed ground (extremely salty sol, wet
beach sand, wet plowed land or hghly magnetc ground condtons) you may not be able to
ground balance the devce. In such a case, frst turn the On/O knob to mneral 1. If the devce
s stll gettng nose, turn t to mneral 2 or mneral 3. Ths wll elmnate the nose and false
sgnals caused by mneralzaton. However, you may experence a decrease or fadng n the
sgnal obtaned from certan metals at maxmum depths.
As mentoned before, especally on grounds wth hgh ron content such as wet salt water
beach sand and wet plowed land, t s recommended that you search n mneral 2 or 3 mode,
brng the ron dscrmnaton to maxmum level and turn the ron swtch o.
SIGNAL AUDIO BOOST
Please note that sgnal audo boost should be used on a temporary or as-needed bass because t wll not only boost the
target sgnal audo but t wll also boost the loudness of ground nose and false sgnals. Therefore, t s recommended to keep
the swtch at poston 1 and turn t to poston 2 or 3 only when you want to verfy a weak metal sgnal and then turn t o
agan.
The sgnal audo boost swtch boosts the sound of weak sgnals receved from small or deep
metals makng t easer for you to detect those uncertan targets.
At poston 1, the booster s o. At 2, the sgnal audo wll be hgher and at 3, t wll be heard
at ts maxmum.
In general, when searchng n wet salt water beach sand, the most deal settngs are the maxmum level of the ron dscrmnaton,
ron swtch o and mneral 2 or 3 modes. You can also use these settngs when searchng n wet plowed land wth hgh ron eect.
2) It enables metals contanng ron to produce a low tone and to be dscrmnated more easly. Dscrmnaton starts at about
level 4 - 6. Below ths level, all metals ncludng ron wll produce a non-ferrous (hgh) tone and generally speakng the devce wll
perform at ts maxmum depth. In addton, ron swtch wll not be actve below ths level.
CONTROLS
16
O
On
Mineral 1
Mineral 2
Mineral 3
SIGNAL AUDIO

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nokta Velox One and is the answer not in the manual?

Nokta Velox One Specifications

General IconGeneral
BrandNokta
ModelVelox One
CategoryMetal Detector
LanguageEnglish

Related product manuals