EasyManua.ls Logo

Nolan N104 - Page 19

Nolan N104
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
 1?30A4>:=,9/:='!$:;09492.7:>49280.3,94>8>,=0/,8,20/:=8,7
1@9.?4:9492/:9:?@>0?3030780?,9/.:9?,.?4880/4,?07D,:7,9,@?3:
=4E0//0,70=
(!# %% #
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector reduces unpleasant infiltrations of air under the chin.
See Fig. 10 for the assembly and disassembly.
(#
The Wind Protector can be easily removed. You can check the correct assembly of
this accessory by pulling it gently towards the inner part of the helmet with your
thumb and forefinger. If it moves, repeat the assembling operations.
# '#  #%!
To remove and/or reassemble the inner comfort padding, open the helmet chin guard
and lift the VPS.
!# '
1.1 Open the chin strap (see specific instructions) and unfasten the fastening hook-
and-loop strips of the roll neck. Then pull the front padding of the left cheek pad
towards the inside of the helmet to undo the snap fasteners on its back (Fig. 11B).
1.2 Remove the padding of the left cheek pad from the helmet by pulling the left chin
strap out of the cheek pad slot.
1.3 Repeat these steps with the padding of the right cheek pad.
:?0:9:?=08:A0?30;:7D>?D=090.3006;,/>
# # '
1.1 Remove the rear flaps of the roll neck from their seats on the shell sealing edge
as shown in Fig. 12.
1.2 Check that the front fixing hook-and-loop strips of the roll neck are released from
the cheek pads and once the cheek pads are removed undo the (left and right)
front fixing eyelets as shown in Fig. 11A.
1.3 Remove the roll neck.
## '
Before removing the liner, remove the roll neck as indicated in the previous paragraph.
1.4 Remove the rear flaps of the liner from their seats on the shell sealing edge as
shown in Fig. 13.
1.6 Hold the front left part of the liner and pull it upwards in order to remove the flap
from the support fixed to the polystyrene inner shell (Fig. 14). Repeat the same
steps to remove the front central and right flap.
1.7 Completely remove the liner from the helmet.
(# : 9:? =08:A0 ?30 #  $%# >D>?08 >00 '09?47,?4:9 ;,=,
2=,;3,9/:=,9D:?30=.:8;:909?>1=:8?3030780?
19
N104 0072_N104 0072 26/08/11 09.50 Pagina 19

Related product manuals