Nomadic NC-X3 - Maintenance Procedures; Maintenance: Routine Schedule; Product Disclaimers

NC-X
3
Instalation Manual 231226 8 Nomadic Cooling Co
INSTALLATION STEPS
1. Mark your 14”x 14” rooftop opening. DIY
Kit includes a cardboard tempate. Cut
from the exterior of your vehicle.
Never cover AC unit top fan.
When determining AC unit location,
be sure to allow for the shroud (cover)
when positioned on the roof.
Make sure there is no electrical or
other encumbrances in the way.
Do not cut into structural beams.
2. Make sure the panned opening is
centered from all four sides. This gives
the best chance for easy instalation.
Use painter’s tape and a permanent
marker to draw your 14”x 14” cutline.
Make multiple passes with the marker.
If you make a mistake repace the
tape and try again. Measure repeat-
edly to make sure your lines create a
perfect 14”x 14” square.
3. Drill each corner of your markings
through the roof. This will make it easier
to detect the location of your 14”x 14”
opening from the underside of your roof.
Use a 1/8” drill bit for corner holes.
4. Cut on your lines using a jig saw, nibbler
or cutting wheel.
Use a sander or file to smooth out the
rough edges after cutting.
14”
14”
14”14”
Exterior Roof
Vehicle Front
Exterior Roof
14”
14”
14”14”
Exterior Roof