Nomadic X Series - Remote Control Functions; Power and Mode Operations; Timer Functionality; Temperature and Voltage Query

X Series AC Unit Operation Guide Version 1.0-100323 4 Nomadic Cooling Co
REMOTE CONTROL DESCRIPTION
1. ON-OFF: Turns unit on and off
2. Power Mode is used for fast cooling.
3. Eco Mode is used when resting or
reading is preferred.
In Power Mode, the default airflow is the
biggest with the manual adjustment.
In Eco Mode, compressor is running in
low frequency, airflow is defaulted as
smallest with manual adjustment.
Note: Strong recommendation for Power
Mode less than 20 minutes. Long time
operation will significantly shorten the
duration of use.
When cabin temperature is below 30ºC,
Auto Mode is preferred.
In different modes, users can adjust the
air volume according to their needs.
4. Timer: Use Temp “+” or “-” to set the
timer using half hour increments, for up
to 10 hours. Press the timer key again to
cancel the timer.
5. Temp Query: Cycle switching between
ambient temperature and evaporator
surface temperature.
6. Voltage Query: Dispays voltage reading
7. Temp “+”: Temperature Increase
8. Temp “-”: Temperature Decrease
9. Airflow “+”: Increased Air Speed
10. Airflow “-”: Decreased Air Speed
11. Auto Mode: Automatically sets thermo-
stat to 78º
12. Mode: Normal, ECO, Powerful
(The current product status is in the select-
ed heating and ventiation mode, only the
indoor blower works.)
Error Codes and Trouble Shooting
Failure analysis of no cooling or poor effect:
(1) The power cord connected is too long and
too thin. Poor connection at connector.
(2) No refrigerant or insufficient refrigerant.
(3) Eco mode is used when the temperature
is too high.
(4) Compressor or condensing fan does
not work.
(5) The evaporator or condenser is dirty
or blocked.
S
E
A
1. On-Off 4. Timer
12. Mode 9. Airflow “+”
8. Temp “-” 7. Temp “+”
10. Airflow “-” 2. Power Mode
11. Auto Mode 3. Eco Mode
5. Temp Query 6. Voltage Query