Norand Mono - Project Settings

2/8/2021 Norand Mono Manual
localhost:3000/manual 20/23
as well. To avoid going too wild, only the synth parameters are randomized,
not the modulation parameters. The Freq and detune parameter are never
randomized to keep the randomized step in tune.
To randomize a step, hold [FUNC] + [TEMPO], and hit the desired [SEQ] key.
Parameter randomizer
The parameter randomizer basically creates a random automation on a
modulation or synth parameter. There is a 50% chance that a parameter
oset is added on each step. The random value is also restricted to a range
set by the musician, the osets will never exceed these values.
To randomize a parameter, hold [FUNC] + [TEMPO], turn the desired
parameter to the desired lower value, then turn it the other way, to the
desired upper value. On releasing [FUNC], the parameter will be
randomized.
Accent and slide randomizer
To randomize accent or slide on a pattern, hold [FUNC] + [TEMPO], and hit
[ACCENT] or [SLIDE]. This will clear the current accent/slide and place
accent/slide on note trigs at random.
Mod note randomizer
The Mod note randomizer is the wildest of all. It allows musicians to
randomize a Mod Note in the Mod Note mode. Since it is not limited to the
48 parameter osets per step, it randomizes every single synth and
modulation parameters. The result will usually be extremely weird bleeping
noises, but we all love that don’t we ?
To randomize a Mod note you need to enable the Mod Note mode with [UP]
+ [DOWN]. Hold [FUNC] + [TEMPO], then hit one of the 8 bottom [NOTE]
keys to randomize the desired mod note.
Project settings
First things rst, let’s be honest - editing settings on Mono is not the best
user experience. There is no way to make the process easy without a
display, so you either need a good memory, or you need to keep the manual
close. The process is always the same though, hold [FUNC], hit the desired
settings, use the [SEQ] and [PAGE] key to select the desired value. Exit by
hitting [FUNC] again.
MIDI/Clock
This setting allows user to set the Mono MIDI channel and clock source.
Use the [SEQ] button to select the midi channel from 1 to 16, and use the
page button to set the clock source. there are 4 clock source :
Internal [PAGE 1] (default) : Mono uses its internal clock, and [RUN] key to
manage playback.
MIDI [PAGE 2] : Mono uses the clock received on the MIDI port, playback
operation is handled with MIDI start stop messages.
USB [PAGE 3] : Mono uses the clock received on the USB port, playback
operation is handled with MIDI start stop messages.