Quick-Start
If you are eager to start making music with Mono right now, this couple of
pages should get you started.
Panel Layout
Synthesis section
A Oscillator section : 2 oscillators with quantized frequency, bipolar
detune and continuously variable waveform controls. Mod section with
Thru-Zero Frequency Modulation (TZFM) and hard-sync from oscillator
1 to oscillator 2.
B Mixer section : set oscillators level. Above a certain oscillator level,
the filter will softly saturate said oscillator, resulting in interesting
timbres.
C Filter section : state Variable Filter with cutoff, resonance,
continuously variable state, and bipolar envelope amount controls, as
well as a keyboard tracking “Follow” switch. Filter is self-resonant at
maximum resonance.
D Main envelope : a classic ADSR envelope. It is rettringering,
meaning a new note will restart the cycle.
E Output volume : pretty self-explanatory, although it’s a digital control
so it can also be modulated (Audio rate amplitude modulation ? Oh
yes.)
F X-Modulator : parameter-dedicated modulation oscillators with 4
types - low frequency, low frequency synced, audio-rate, audio-rate
quantized -, 4 waves - sine, triangle, square, sawtooth-, rate control
and bipolar amount control.
G X-Envelope : parameter-dedicated AD envelope with attack, decay,
and amount controls.
Each of the 20 synthesizer parameters have their own dedicated X-Mod
and X-Env (even sync and follow). To access it, just gently move the knob of
the parameter you want to select and the parameter LED will turn on.
Sequencer section
To Next Page
Need help?
General