EN
116
Installation instructions
• The device is designed to be powered by 12 V direct current.
Before installing the unit, check that your vehicle has a 12 V
power supply with the negative pole going to ground.
• The negative pole of the battery must be disconnected before
the device is connected. This reduces the probability of
damaging the device by an accidental shorting of the circuit.
• Check that the unit is correctly connected according to the
coloured leads based on the wiring diagram. An incorrect wiring
connection could cause the malfunction of the unit or damage
to the vehicle's electrical system.
• Do not forget to connect the loudspeaker lead marked (-) to the
(-) terminal. Never connect the left and right loudspeaker leads
together or to the car body.
• Do not cover the ventilation openings on the unit. Blocking
them will increase the temperatures inside the unit, which may
damage it or cause a fire.
• This device can playback MP3 and WMA digital sound file
formats.
• Do not attempt to repair the unit, modifications to the unit may
cause a malfunction or damage the device.
• Stop the vehicle before performing anything that could interfere
with driving.
• Do not turn on the device in extremely high or low temperatures.
The normal operating temperature is between -10 and +50 °C.
ATTENTION
Ensure correct connection, particularly the power
supply (larger draw) and backup memory (smaller
draw). This will keep the current draw in the turned off
state to a minimum and maintain your set preferences
in the car radio memory.
To Next Page
Loading...
Need help?
General
