68
TROUBLE SHOOTING
Error Reason Solution
1.
“Clamps icon” on top
left blinks
Clamps might be wrongly
plugged.
Reverse the battery
connections.
2.
“COOLING icon” in the
bottom on
The unit’s temperature is
higher than 55˚C.
Bring the unit into a colder
enviroment and wait until the
unit to recover to 40˚C.
3.
“COOLING” or
“OVERLOADCOOLING”
icon in the bottom and
10 minutes counting
show in the LCD
1) The unit’s power is not
enough.
2) The unit has been tried
five times in 10 minutes
so the internal battery is
hot.
1) Double check your engine size
if it is suitable for this unit.
2) Allow the unit to cool.
Bring the unit into a colder
enviroment.
4.
“READY” is not on after
all connecting well
Connected battery is
below 2V or above 12.6V.
1) Make sure your car battery
is 12V.
2) Charge your car battery.
3) Remove all the loads
(eg: heater, air conditioner,
light etc) and try again.
5.
“F1" on The temperature is lower
than —25˚C
Bring the unit to a warm
environment
6.
"F2" on The internal circuit is
broken
Send the unit to the
professional place for repair
7.
"F3" on The unit temperature is
below 10°C or higher than
45°C.
The booster can only be
charged between 10°C and
45°C.
8.
"F4" on Timeout for charging The battery possibly goes bad
and do not advise customer to
use again
To Next Page
Loading...
