Need help?Do you have a question about the Norcold 1200LR and is the answer not in the manual?
General| Type | Absorption Refrigerator |
|---|---|
| Cooling Method | Absorption |
| Power Source | AC/DC/Propane |
| Energy Consumption (Propane) | 1.5 lbs/day |
| Refrigerant | Ammonia |
| Thermostat Control | Manual |
| Automatic Energy Selection | Yes |
| Door Style | Single Door |
Specifies the required DC and AC voltage ranges for operation.
Indicates an LP gas ignition or re-ignition fault.
Signals the refrigerator door has been left open for over two minutes.
Signals that the AC input voltage is below the acceptable minimum.
Signals that the AC input voltage is above the acceptable maximum.
Indicates a fault within the refrigerator controls, reverting to backup system.
Signals that the DC control voltage is below the acceptable minimum.
Signals that the DC control voltage is above the acceptable maximum.
Indicates the AC relay is stuck in the closed position.
Signals the AC heater failed open, without current flow.
Indicates a failure in the flame sense circuit.
Signals AC heater current is outside specified tolerance.
Troubleshooting steps for when the display panel shows no output.
Troubleshooting steps for when the refrigerator is not making ice.
Troubleshooting steps for reduced ice production.
To Next Page
